JBL LSR4328P Owner's Manual page 32

Reference - Equalization
The LSR4328P and LSR4326P provide six factory EQ presets. (A complete listing of all
parameters for the factory presets is presented in Appendix A). To recall a preset, press the
front panel PRESET button on any networked speaker (it will begin blinking), then use the
+
or - buttons to select the desired preset. Preset 1 is indicated by the left-most block of five
LEDs lighting green, and each successive block oftive LEDs indicates the next preset. Thus,
for example, if you see the right-most block offive LEDs lit, that is an indication that you are
calling up Preset 6. If no preset is selected while the PRESET button is flashing (for about 3
seconds) the system will return to its current settings. See page 31 in this manual for
illustrations showing the LED display for each preset.
Preset 0 is a special case . Indicated by the lighting of a single LED on either side of the center
(-15) mark, this is the user memory area, which always contains a copy of the last recalled
preset. Changes made to preset 0 remain in memory even after the LSR4300 is powered
down; however, they are lost when one of the six factory presets is recalled. If this preset is
selected prior to the time-out of the preset function, no change is made to the current settings.
LSR4300 Control Center software allows the creation and storage of custom user
equalization curves, which can then be loaded into memory, overwriting any of the factory
presets. For more information, see the LSR4300 Control Center owner's manual.
Additionally, the Control Center Software allows you to select the frequency of EQ boost
or attenuation.
Whenever a preset is selected, the LF and HF buttons will illuminat to indi ate whether the
currently selected preset contains LF and/or HF boost or Cllt (the button corresponding to the
most recently changed band will flash). nle preset becomes active when the PRESET button
stops fl ashing (after 3 seconds). [f no preset is selected, the system will return to its current
settings . lf preset '0" is selected before the 3 second time-out of the function, no change is
made t the EQ settings.
Equalization presets can be stored in memory or to disk with the lise of the supplied LSR4300
Control Center oftware. Changes made to a preset arc held in memory even when the
LSR4300 is powered down; however. without the lise of the software, any changes made will
be lost when another prese t is called up.
• A preset ca n be deactivated by pressing the EQ ON button until the light goe out, or by
manually setting both the LF and HF values to 0 dB.
29