Epson EH-LS10000 User Manual page 94

Configuration Menu
Function
Operation Direct Power On
Sleep Mode
Illumination
Trigger Out 1
Trigger Out 2
High Altitude Mode On, Off
Lens Adjustment
Mode
Menu/Settings
On, Off
Off, 5min., 10min.,
20min.
On, Off
Off, Power, Ana-
morphic Wide
1, 2, 3
93
Explanation
You can set up the projector so that projection
starts as soon as the power cord is plugged in
without any button operations.
Note that when this is set to On, projection starts
if power is restored after a blackout or other
power outage and the power cord is still plugged
into the projector.
If the set time is exceeded and no signal is input,
the projector is automatically turned off and en-
ters standby mode. When set to Off, the projec-
tor never enters sleep mode. When in standby
mode, press the button on the remote con-
trol or the button on the control panel to
start projection.
Set this to Off if the light from the indicators on
the control panel bothers you when watching a
movie in a dark room.
Set the Trigger Out function to communicate the
projector's power on status to external devices.
Trigger Out 1 corresponds to the Trigger out 1
port, and Trigger Out 2 corresponds to the Trig-
ger out 2 port.
When set to Off, no voltage is output from the
Trigger out 1/Trigger out 2 ports.
When set to Power, voltage is output from the
Trigger out 1/Trigger out 2 ports when the pro-
jector is on.
For Anamorphic Wide, when the projector is on
and Aspect is set to Anamorphic Wide or Horiz.
Squeeze, voltage is output from the Trigger out
1/Trigger out 2 ports.
If you change this setting, the new setting will
take effect the next time you turn the projector
on.
Set this to On if you are using the projector above
an altitude of 1500 meters.
Set the amount of lens movement for the focus,
zoom, and lens shift adjustments when pressing
the
The default value is 2. Select 1 to make the
amount of movement smaller, and select 3 to
make the amount of movement larger.
buttons once.