Problems When Projection Starts; Problems With The Remote Control - Epson EH-LS10000 User Manual

Troubleshooting
The Panel Alignment adjustment is not satisfactory or difficult to achieve
Check
Does the Projection setting match the pro-
jector's installation position?
Is the projection surface suitable?
Were adjustments made immediately after
the projector was turned on?
Is the image size suitable?
Is the shifted color magenta?
Do the lines in the pattern look fuzzy or out of
focus?

Problems when projection starts

The projector does not turn on
Check
Is the power turned on?
Is Child Lock set to On?
Do the indicators turn on and off when the
power cord is touched?

Problems with the remote control

The remote control does not respond
Check
Is the remote control light-emitting area
pointing towards the remote receiver on the
projector during operation?
Is the remote control too far from the projec-
tor?
Is direct sunlight or strong light from fluores-
cent lamps shining onto the remote receiver?
The panel alignment adjustment method changes depending
on the Projection setting. Make sure the Projection setting
matches the projector's installation position.
jection p.91
For best results, the projection surface should not be colored or
textured, otherwise the adjustment grids will be difficult to align.
Project onto a screen and so on that is white and does not have
a pattern.
To obtain stable image quality, leave the projector on for a while
before making adjustments.
The projected image should be a minimum of 60".
Adjust R (red) and B (blue) for Select Color since magenta is a
mixture of red and blue.
Adjust the focus. p.32
s
Press the button on the remote control or the
on the control panel.
When Child Lock is set to On from the Configuration menu, hold
down the button on the control panel for approximately
three seconds, or perform operations from the remote control.
Settings - Lock Setting - Child Lock
s
Turn off the projector, and then disconnect and reconnect the
projector's power cord. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
Epson Projector Contact List
center.
s
Point the remote control towards the remote receiver. Also,
check the operating range.
Check the operating range.
Set the projector up in a location where strong light does not
shine onto the remote receiver.
109
Remedy
Settings - Pro-
s
Remedy
p.91
Remedy
p.25
s
p.25
s
button