Epson EH-LS10000 User Manual page 109

Troubleshooting
Image colors are not right
Check
Is the image signal format setting correct?
Are the cables connected correctly?
Is the contrast adjusted correctly?
Is the color adjusted correctly?
(Only when projecting images from a video
device)
Are the color saturation and tint adjusted cor-
rectly?
Images appear dark
Check
Is the image brightness set correctly?
Is the contrast adjusted correctly?
Projection stops automatically
Check
Is Sleep Mode enabled?
When Video is input
If nothing is projected even when Video Signal is set to Auto
from the Configuration menu, set the signal that matches the
connected device. Settings - Input Signal - Video Sig-
s
nal p.91
When Component is input
If nothing is projected even when Component is set to Auto
from the Configuration menu, set the signal that matches the
connected device. Settings - Input Signal - Compo-
s
nent p.91
Check that all the cables required for projection are securely
connected. p.20
s
For the Video and Component ports, make sure the connector is
the same color as the cable port.
Adjust the Contrast setting from the Configuration menu.
Image - Contrast p.86
s
Adjust the Advanced setting from the Configuration menu.
Image - Advanced p.86
s
Adjust the Color Saturation and Tint settings from the Config-
uration menu. Image - Color Saturation/Tint
s
Adjust the Brightness setting from the Configuration menu.
Image - Brightness
s
Adjust the Contrast setting from the Configuration menu.
Image - Contrast p.86
s
If the set time is exceeded and no signal is input, the laser turns
off automatically, and the projector enters standby status. The
projector returns from standby status when you press the
button on the remote control or the
panel. Do not look into the laser when returning from standby
status. If you do not want to use Sleep Mode, change the setting
to Off. Settings - Operation - Sleep Mode
s
108
Remedy
p.21
s
Remedy
p.86
Remedy
button on the control
p.91
p.86