Haier DW12-EFM Service Manual page 9

Serial Number:
6.4 Hot Water Connection
The water supply to the appliance can also be connected to the house's hot water line (centralised
system,heating system),as long as it does not exceed a temperature of 60¡æ.
In this case,the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly
reduced.
The connection must be made to the hot water line following the same procedures as those for the
connection to the cold water line.
6.5 Anti-Flooding Protection
The dishwasher is equipped with a system that stops the supply of water in the event of a problem with
Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the sink, making
sure to avoid bending or crimping it. Use the special plastic support that comes with the appliance (see
Fig.2). The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in
r.
wate
Version:00.00
Dishwasher
the water supply hose, or leaks within the unit, in order to
prevent damage to your home.If for any reason the box
containing the electrical components happens to get
damaged, remove the plug for the appliance from the socket
immediately. In order to guarantee that the anti-flooding
feature operates properly, the "A" box with water supply hose
must be
Fig .1.No other type of connection is acceptable. The water
supply hose must not, under any circumstances, be cut, as it
contains electrical parts which are live. If the length of the
hose is not adequate to make a proper connection, the hose
must be replaced with one which is long enough. This hose
is available upon request from specialised retailers and
service centers.
6.6 Drain Hose Connection
Model: DW12-EFM
attached to the water supply tap as shown in
Edition: 2005-7
9/23