Philips CID3292 Quick Start Manual

Register your product and get support at
www.philips.com/welcome
ENG Quick Start Guide
3
4
CID3292_00_QSG_V2.0.indd 1
CID3292
1
a
b
c
d
English
Set date and time
1
Press MENU.
Install the car audio 1
»
The main menu is displayed.
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
2
Take out the original car audio and keep
the screws.
3
Mount the supplied mounting brackets
onto the unit with the supplied screws.
a
4
Connect wires 2 .
2
5
Tap [Settings].
Take off the two screws on the top side of
3
the unit. b Tap [Time].
6
Slide the unit into the dashboard until a »
The date/time setup menu is displayed.
click sound is heard. c
7
Fix the unit onto the dashboard with
screws. d
8
Reconnect the negative terminal of the car
battery.
Turn on
Set date
Caution 1
Tap [Date].
2
Risk of road accidents! Never watch video or Tap the displayed date information.
adjust settings while you drive. »
A submenu is displayed.
3
1 Tap
Press to turn on the unit.
» Set time mode
The available OSD (On-Screen Display)
1
languages are displayed.
Tap [Time mode].
2
Tap [12H] or [24H] to select time mode.
Set time
1
Tap [Time].
2
Tap the displayed time.
»
A submenu is displayed.
3
Tap
2
Tap a language.
»
The OSD language is changed to the
selected language immediately.
2
Yellow Green
Yellow
Connect to the positive (+) terminal of
reverse driving light
Gearbox
Adjust screen
To turn off the screen
1
Press DISP for over 2 seconds
To adjust screen brightness
1
Press DISP.
2
Rotate VOL to adjust brightness.
Use map
Note
You may need to upgrade the map (sold
separately) before using it (see "Upgrade the
map" section)
1
Tap the upper left corner to display home
menu.
2
Tap [Navigation].
»
The navigation menu is displayed in a
few seconds.
3
Refer to the map manual to operate the
navigation tool.
Listen to Radio
1
Tap to display home menu.
2
Tap [Radio].
or to set year, month and day.
»
Band and frequency information is
displayed.
or to set hour and minute.
3
Tap on FM or AM to select band:
4
or to tune to a radio station
by step.
Blue
c
AV system AV system
AUX AUX
Remark:
3
Enter default password "0000".
Play disc
3
»
if pairing succeeds. phone call record is
You can play video, audio or images stored on the displayed.
following discs:
DVD video, DVD-R, DVD-RW
VCD
Audio CD, CD-R, CD-RW
1
Insert the disc into the disc slot with label
side facing up.
»
Play starts automatically.
»
To remove the disc, press the button.
Make a call
Connect USB device 4
1
Pair the phone with the unit.
2
Tap to display the home menu.
1
Open the USB door.
3
Tap [Bluetooth].
2
Insert the USB device to the USB socket.
»
The Bluetooth menu is displayed.
»
Play starts automatically.
Note
To remove the USB device, switch to disc,
Play with Bluetooth device
4
Tap or to select the paired phone, then
tap .
Pair the Bluetooth-enabled devices
5
Tap or to search for phone number
To connect your Bluetooth device to the unit, you
from the following list:
need to pair the device to the unit. Pairing needs
only to be done once.
You can pair up to eight devices.
1
Search for Bluetooth device with the device.
2
Select "CID3292" in the pairing list.
Or tap to dial number directly, then tap
to dial.
Yellow
Rear display
Yellow
Rear display
Radio antenna
GPS antenna
Optional accessory
Amplifier
Connect the AV IN wire which is marked as c to the AV IN socket on front panel.
Receive call
By default, all incoming calls are received
automatically.
1
If there is incoming call, [Incoming call...]
Bluetooth microphone.
2
When conversation ends, tap (red) to
terminate the call.
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
CID3292_00_QSG_V2.0
6/4/2010 4:18:58 PM