Read This First - Panasonic AG-EC4G Operating Instructionsc

AG-EC4G(VQT2H46)_EGFISJ.book 1 ページ ２００９年１０月８日 木曜日 午後４時５分
ENGLISH

Read this first!

WARNING:
To reduce the risk of fire or electric
shock, do not expose this equipment
to rain or moisture.
To reduce the risk of fire or electric
shock, keep this equipment away from
all liquids. Use and store only in
locations which are not exposed to the
risk of dripping or splashing liquids,
and do not place any liquid containers
on top of the equipment.
CAUTION:
The mains plug of the power supply cord
shall remain readily operable.
The AC receptacle (mains socket outlet)
shall be installed near the equipment and
shall be easily accessible. To completely
disconnect this equipment from the AC
mains, disconnect the mains plug from
the AC receptacle.
CAUTION:
Do not remove panel covers by
unscrewing them.
To reduce the risk of electric shock, do
not remove the covers. No user
serviceable parts inside.
Refer servicing to qualified service
personnel.
CAUTION:
To reduce the risk of fire or electric shock
and annoying interference, use the
recommended accessories only.
indicates safety information.
The rating plate is on the underside of the unit.
EEE Yönetmeliğine Uygundur.
EEE Complies with Directive of Turkey.
E-1
FCC Note:
This equipment has been tested and found to
comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instruction manual,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.
The user may find the booklet "Something
About Interference" available from FCC local
regional offices helpful.
Warning :
To assure continued FCC emission limit
compliance, follow the attached installation
instructions and the user must use only
shielded interface cables when connecting to
peripheral devices. Also any unauthorized
changes or modifications to this equipment
could void the userís authority to operate this
device.