Basic Operations - Kenwood drv-410 Instruction Manual

Basic Operations

Inserting and Removing an SD Card
Turn off the power of the device and then insert
an SD card into the SD card slot until you hear
a clicking sound. Be careful with regard to the
orientation of the card.
To remove the SD card, turn off the power of the
device and then press the SD card so that it pops
up and remove the SD card by pulling it out.
• Be sure to format an SD card with the
device.
• When an SD card is formatted, all files
including protected files are deleted.
Turing the Power On/Off
Turning on the accessories power (ACC) switch
or starting the engine of the vehicle turns on
the power of the device and starts continuous
recording. Turning off the accessories power
(ACC) turns off the power of the device and
switches to parking recording mode.
To Turn the Power On/Off Manually
When the accessories power (ACC) is on, the power
of the device can be turned on or off manually.
• Hold down the [MENU/OK] button for at least 3
seconds while the device is on to turn off the power.
• Hold down the [MENU/OK] button for at least 1
second while the device is off to turn on the power.
• When the power has been turned off
manually, power is consumed because the
device is in standby.
• There are vehicle models such as some
imported vehicles for which the power
to the cigarette lighter is not cut off even
when the engine is turned off. To protect
the battery, remove the cigarette lighter
plug when you get out of the vehicle.
Formatting an SD Card
Before using an SD card, first format (initialize) it
with the device.
1.
Insert the SD card into the SD card slot.
2.
Press the [MENU/OK] button.
MENU appears.
3.
Use the [ J ]/[K] buttons to select
<Format SD card> and then press the
[MENU/OK] button.
1
2
1
4.
Use the [ J ]/[K] buttons to select
<OK> and then press the [MENU/OK]
button.
1
2
1
5.
Press the [MENU/OK] button to end
the procedure.
13