Panasonic SD AG-HPX171E Operating Instructions Manual page 117

Playback
Cannot play even when I
press the play button.
Mosaic-like noise appears
when I cue or review a
tape.
Images do not appear on
the television even though
I have connected the
camera-recorder properly.
Cannot hear any sound
from the camera-
recorder's speaker.
Cannot perform hot swap
playback.
Other
Cannot read the data on
the SD memory card.
The remote control does
not work.
There is a rattling sound
when the camera-recorder
is tilted back and forth.
A clicking sound is heard
when the power is turned
on or when the MCR
mode is switched to the
CAM mode.
• Make sure the MCR lamp is on (press the mode button).
No kind of playback operation can be performed unless this lamp
is on.
• This noise is inherent to digital video technology.
This is normal.
• Make sure the input selector on your television is set to video
input.
Read the television's instructions carefully and select the correct
video input connector for the camera-recorder.
• You may have turned down the camera-recorder's volume control
too far.
Adjust the volume level using the PAGE/AUDIO MON/
VAR button+.
• This unit does not support hot swap playback.
To replace one card with another during dubbing, stop the
dubbing first, and upon completing the replacement, resume it.
• Make sure the SD memory card is formatted correctly.
If it is not, format the card in the unit.
• The battery in the remote control may have run out.
If the remote control fails to work even if it is operated close to the
remote control sensor of the camera-recorder, it means that the
battery has run out. Replace it with new one.
• Make sure the remote control setting is the same for the remote
control unit and the camera-recorder.
If the REMOTE setting is different on the remote control and the
camera-recorder, the remote control will not work.
• There are some parts of the camera that make a rattling sound
in the MCR mode or when the POWER switch is OFF. This is
normal.
• This initialization operation is performed when the camera starts
up.
It occurs due to the construction of the camera and is not
indicative of any trouble.
ENGLISH
P64
——
——
P76
P87
P29
P18
P18
——
——
E-117