Fault or alarm display
Pressing and holding down the button (> 3 s) or pressing it briefly twice:
The motor coasts to a standstill
Pressing the button: Toggling between external command sources and the
BOP-2 as command source.
MANUAL means: Manual control using the IOP buttons
AUTO means: The drive responds to external control commands (e.g.
fieldbus or terminals)
You can also toggle between MANUAL and AUTO mode when the motor is
No symbol is displayed if AUTO mode is activated
Steady-state symbol, does not rotate
Is displayed if the JOG function is activated
Saving drive data on a ROM
This option allows you to transfer all the drive data from the drive's internal memory
(RAM) manually to the non-volatile memory (ROM). This is necessary if changes
have been made via the STARTER commissioning software or if the IOP is in
"Save to RAM" mode.
1. Select Options > Save RAM to ROM.
2. Confirm with OK.
1. Select Options > RAM to ROM.
There is a fault present.
The drive stops. Clear the fault.
There is an alarm (e.g., overtemperature)
The drive keeps running.