Commissioning; Operator Panels; Iop - Siemens G120P Manual

Commissioning

3

Operator panels

3
3.1
3.1.1
3.1.1.1
20
Siemens AG
Commissioning
Operator panels

IOP

Functions
Button Function
Turning the navigation wheel:
 Changing selection
Changing parameters

– Clockwise rotation increases the value.
– Counter-clockwise rotation reduces the value.
Pressing the button
Confirming the selection

Pressing and holding down the button (> 3 s)
Toggling between changing individual digits and changing the whole value

In AUTO mode: no function

In MANUAL mode: pressing starts the drive

In AUTO mode: no function

In MANUAL mode:

– Pressing briefly: OFF1 - the motor comes to a standstill along the set down
ramp (parameter P1121)
– Pressing and holding down the button (> 3 s) or pressing it briefly twice: The
motor coasts to a standstill
 Pressing briefly: Return to the previous display
Pressing and holding down the button (> 3 s): The IOP returns to the status

screen
Pressing the button:
 Information output about the actual display
You return to the previous display by pressing again

Pressing the button: Toggling between external command sources and the IOP

as command source.
– MANUAL means: Manual control using the IOP buttons
– AUTO means: The drive responds to external control commands (e.g.
fieldbus or terminals)
When you toggle to MANUAL mode, the motor continues running at the last
setpoint speed selected.
When you toggle to AUTO mode, the motor stops.
CM2G5111en
2014-05-16