Functions In Diag Mode; Initial Settings Used To Start Diag - Yamaha RX-V3300 Service Manual

Av receiver/av amplifier
Hide thumbs Also See for RX-V3300:
Table of Contents

Advertisement

• Functions in DIAG mode

In addition to the DIAG menu items, functions as listed
below are available.
• Input selection, 6CH input
• Center/Rear/Rear Center/Sub-woofer level adjustment
• Muting
• Speaker relay A/B
• Power on/off
• Master volume
* Functions related to the tuner and the set menu are not
available.
* It is possible to confirm Menu No.14 IF STATUS while
keeping the signal process (operation status) of each
DIAG menu by using the input mode key of the main
unit.

• Initial settings used to start DIAG

The following initial settings are used when starting DIAG.
When DIAG is canceled, these settings are restored to
those before starting DIAG.
• Master volume: -40dB
• Input: DVD (6CH INPUT OFF)
• Effect level: 0dB
• Audio mute: OFF
• Speaker relay A/B: ON
• Speaker setting: LARGE / BASS OUT = BOTH
• DIAG menu: YSS938 (1. ANALOG BYPASS)
● ダイアグ中の機能
ダイアグメニューの他に、以下の機能が動作します。
・インプット切り換え、6CHインプット
・センター、リア、リアセンター、サブウーファーレベル
調整
・ミューティング
・スピーカーリレーA/B
・パワーオン/オフ
・マスターボリューム
※ チューナー関連、セットメニュー関連は機能しません。
※ 本体のINPUT MODEキーにより、各ダイアグメニュー
の信号処理 (動作状態) を維持したままメニューNo.14
"IF STATUS" の確認ができます。
● ダイアグ開始時の初期設定
ダイアグ開始時に以下のような設定になります。ダイアグ
解除時にはダイアグ開始前の状態に戻ります。
・マスターボリューム: -40dB
・インプット: DVD (6CH INPUT オフ)
・エフェクトレベル: 0dB
・オーディオミュート: オフ
・スピーカーリレーA/B: オン
・スピーカー設定: LARGE / BASS OUT=BOTH
・ダイアグメニュー: YSS938 (1. ANALOG BYPASS)
RX-V3300/DSP-AZ2
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsp-az2Zrx-v33

Table of Contents