New Energypak; Charging - Giant E-bike User Manual

3.2.3 New EnergyPak

A new EnergyPak is shipped in a protective 'hibernate' state. Such an EnergyPak needs to be activated
before it can be used;
• A 'hibernate' EnergyPak can be recognized by pushing the energy level check button. The LED's of
the EnergyPak will not react.
• Plug an active charger in the EnergyPak.
• Unplug the charger from the EnergyPak.
• The EnergyPak is now out of 'hibernate' state. Pushing the energy level check button will result in
lighting up LED's.
• The EnergyPak is ready for usage.
It is not possible for an EnergyPak to go back to 'hibernate' state once it is awoken.
Usually, the dealer will charge the EnergyPak and therefore undo 'hibernate' state.

3.2.4 Charging

• Charging the EnergyPak battery should be at room temperature (±20°C/68°F). Charging below 0°C
or above 40°C (32°F~104 °F) can lead to insufficient charging and can be harmful to the battery life
cycle.
• During charging:
- Charger LED will be continuously red.
- EnergyPak LED's that are continuously red show charge level.
- EnergyPak LED's that blink show charging is in progress.
• Charging is completed:
- When charger's LED turns green.
- All EnergyPak's LED's are red and then switch off.
Integrated downtube EnergyPak outside the bike
1. Insert the key and unlock the EnergyPak, pull
the EnergyPak battery backwards at the top.
2. Lift out the EnergyPak.
3. Connect the charger to the EnergyPak.
4. Connect the charger to an AC outlet.
5. Charging operation can be discontinued at any
given time.
6. Disconnect the charger first from the outlet and
then from the EnergyPak.
5
2
1
3