Appendix C) Changing The Ethernet Default Ip Address; Appendix D) Enabling The In And Out Readers - Honeywell NetAXS-123 Startup Manual

NetAXS-123 Startup Guide, Document 800-05780V2
APPENDIX C) Changing the Ethernet
Default IP Address
1. From the landing page, click on Ethernet/USB in the
Communications section.
2. Locate the Ethernet IP Address, replace within the Network
Tab, and update with new values.
Note: Please check with your network administrator before
changing the IP address since inputting incorrect values could
impact the surrounding network.
3. Edit Subnet Mask and Default Gateway, if required.
4. Click Submit to submit the changes.
5. Click OK to allow panel to reboot and then click OK again to
acknowledge "Reboot this Panel Now?".
6. After panel reboots, connect to new address using the https://
secure connection.
©
2013 Honeywell, Inc. www.Honeywell.com
APPENDIX D) Enabling the In and Out
Readers
NOTE:
In order to connect an In and Out reader, BOTH readers
must have the Hold line for proper operation.
1. Wire In and Out reader per diagram inside the front cover.
Note: Make sure to connect Hold and Tamper lines
appropriately.
2. From the landing page, select the appropriate door in the
Configuration section.
3. Click on the Reader B tab.
4. Click to activate Reader B.
5. On Reader B tab, enter the name for Reader B and submit
changes.
16