GE L90 Instruction Manual page 196

5.2 PRODUCT SETUP
• PUSHBTN 1 DROP-OUT TIME: This setting applies only to "Self-Reset" mode and specifies the duration of the push-
button active status after the pushbutton has been released. When activated remotely, this setting specifies the entire
activation time of the pushbutton status; the length of time the operand remains on has no effect on the pulse duration.
This setting is required to set the duration of the pushbutton operating pulse.
• PUSHBTN 1 LED CTL: This setting assigns the FlexLogic operand serving to drive pushbutton LED. If this setting is
"Off", then LED operation is directly linked to
• PUSHBTN 1 MESSAGE: If pushbutton message is set to "High Priority", the message programmed in the
and
ID PUSHBTN 1 ON TEXT
The high priority option is not applicable to the
This message can be temporary removed if any front panel keypad button is pressed. However, ten seconds of keypad
inactivity will restore the message if the
If the
PUSHBTN 1 MESSAGE
settings will be displayed as long as
by
FLASH MESSAGE TIME
displayed. The instantaneous reset of the flash message will be executed if any relay front panel button is pressed or
any new target or message becomes active.
The
PUSHBTN 1 OFF TEXT
only if pushbutton element is in the "Latched" mode. The
PUSHBTN 1 ID
as "Normal" if the
• PUSHBUTTON 1 EVENTS: If this setting is enabled, each pushbutton state change will be logged as an event into
event recorder.
5
5-66
PUSHBUTTON 1 ON
settings will be displayed undisturbed as long as
PUSHBTN 1 OFF TEXT
PUSHBUTTON 1 ON
is set to "Normal", the message programmed in the
PUSHBUTTON 1 ON
setting. After the flash time is expired, the default message or other active target message is
setting is linked to
PUSHBUTTON 1 OFF
setting is "High Priority" or "Normal".
PUSHBTN 1 MESSAGE
L90 Line Current Differential System
operand.
PUSHBUTTON 1 ON
setting.
operand is still active.
PUSHBTN 1 ID
operand is asserted, but not longer than time period specified
operand and will be displayed in conjunction with
PUSHBTN 1 OFF TEXT
5 SETTINGS
PUSHBTN 1
operand is asserted.
and
PUSHBTN 1 ON TEXT
message will be displayed
GE Multilin