Replacement Parts; Use Proper Extension Cord - Hitachi C 10FCD Instruction Manual And Safety Instructions

English
N ever raise the sa w blade fro m the w orkpiece until it has first co m e to a co m plete stop.
17.
N ever place your lim bs inside of the line next to w arning sign "
18.
This m ay cause hazardous conditions.
N ever use abrasive type blades on this sa w.
19.
N ever expose to rain or use in da m p locations.
20.
N ever cut ferrous m etals or m asonry.
21.
WARNING
FOR YOUR OWN SAFETY READ THIS INSTRUCTION MANUAL BEFORE OPERATING THE
COMPOUND SAW
Alw ays w ear eye protection w hen using the co m pound sa w.
1.
Alw ays keep hands out of the path of the sa w blade.
2.
N ever operate the sa w without the guards in place.
3.
N ever perform any freehand operation with the co m pound sa w.
4.
N ever reach around the sa w blade.
5.
Alw ays turn off tool and w ait for sa w blade to stop before m oving w orkpiece or changing settings.
6.
Alw ays disconnect po w er before changing blade or servicing.
7.
Sa w blade dia m eter is 10" (255m m).
8.
N o load speed is 3800rp m.
9.

REPLACEMENT PARTS

W hen servicing use only identical replace m ent parts.
Repairs should be conducted only by a Hitachi authorized service center.

USE PROPER EXTENSION CORD

M ake sure your extension cord is in good condition. W hen using an extension cord, be sure to use one
heavy enough to carry the current your product will dra w. A n undersized cord will cause a drop in line
voltage resulting in loss of po w er and overheating. Table sho ws the correct size to use depending on cord
length and na m eplate a m pere rating. If in doubt, use the next heavier gage. The sm aller the gage nu m ber,
the heavier the cord.
A m pere Rating
M ore N ot M ore
Than Than
0 – 6
6 – 10
10 – 12
12 – 16
WARNING:
Avoid electrical shock hazard. Never use this tool with a damaged or frayed electrical cord
or extension cord.
Inspect all electrical cords regularly. Never use in or near water or in any environment
where electric shock is possible.
6
MINIM U M G A G E F OR C ORD SETS
Total Length of Cord in Feet (M eter)
0 – 25 26 – 50
(0 – 7.6) (7.9 – 15.2)
18 16
18 16
16 16
14 12
" w hile the tool is being operated.
51 – 100
(15.5 – 30.5) (30.8 – 45.7)
AW G
16
14
14
N ot Reco m m ended
101 – 150
14
12
12