Reviewing Incident Data; Reviewing Data From Internal Memory - Philips M3860A Instructions For Use Manual

To replace a data card:
:
You must turn the FR2+ off (return it to standby mode) before
I M P O R T A N T
you remove the data card, to ensure that no incident data are lost.
1. Press the On/Off button to turn off the FR2+. Never replace the data
card unless the FR2+ is turned off.
2. Remove the loaded data card tray by grasping its handle and pulling it
out of the port.
3. Remove the data card from the tray.
4. Give the data card to the appropriate person in your organization.
5. Because it helps seal the FR2+ against moisture, the data card tray
should always be reinserted into the port of the FR2+. Either load a new
data card into the tray and insert it, or insert the empty data card tray into
the port.

Reviewing Incident Data

Reviewing data from internal memory

Summary information from the last incident that is stored in the internal
memory of the HeartStart FR2+ can be displayed on its screen for review. To
review this information:
1. Remove the data card if one is installed and unplug the pads connector.
2. Remove and reinstall the battery. (Make sure you are using the gray
M3863A FR2 standard battery or the blue M3848A rechargeable
battery, not the yellow training & administration pack.)
3. Select
REVIEW INCIDENT
4. Observe and record, if desired, the summary information displayed on
the screen:
how long the incident recorded by the FR2+ lasted, and
how many shocks were delivered during the incident.
This information stays in the FR2+'s memory and can be displayed for review
until the next time the FR2+ is used. At that time, the data from the new
incident will be displayed.
from the menu. A new screen comes up.
D a t a M a n ag e m en t an d R e v ie w
7-3
7