Nokia RD40 Manual page 47

Nokia RD40 Modification:
P a g e 4 o f l 3
A trace has to be cut nearby the Voltage regulator.
After this is done a wire must be connected , to the tracejust cut and Pin 3 of the 8 pole connector.
After this modifications the RF PCB is suitable for use.
Step 4.
Building of the RíTx/Audio board.
The layout for the RíTx/Audio can be found here pd{\NrikiaPCBlal,out.PDF
After you made a PCB you have to drill the holes in to the PCB for the components.
For the adjustment you have also to drill a hole under the adjustment points ofthe PCB
which are displayed in the following picture.
mhtml:file:/A\.PSF\Share\Nokia%2ORD4O\Nokia%2}RD4l%20Modification.mht 2t8/2008