Connection To The Mains Supply - Breville TT30 Instruction Manual

TT30-TT33_Rev3.fm Page 15 Tuesday, March 1, 2005 4:28 PM

CONNECTION TO THE MAINS SUPPLY

When using electrical appliances, basic safety
precautions should always be followed.
WARNING:THIS APPLIANCE MUST BE
EARTHED.
If this appliance is fitted with a rewirable BS1363, 13
amp plug, the fuse should be rated at 13 amps and be
ASTA approved to BS1362. However if the plug is
unsuitable, it should be dismantled and removed from
the supply cord and an appropriate plug fitted.
If this appliance is fitted with a moulded BS1363 13 amp
plug, the fuse should be rated at 13 amps and be ASTA
approved to BS1362. If the fuse in a non-rewirable plug
needs to be changed, the fuse cover must be refitted.
The appliance must not be used without the fuse cover
fitted.
In the event of the plug being unsuitable, it should be
changed and an appropriate plug fitted. If you remove
the plug it must not be connected to a 13 amp socket
and the plug must be disposed of immediately.
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows:
NOTE: The wires of the mains lead are
coloured in accordance with the
following code:
GREEN & YELLOW = EARTH
BLUE = NEUTRAL
BROWN = LIVE
GREEN & YELLOW
(earth)
E
13 AMP FUSE
L
BLUE
(neutral)
N
BROWN
(live)
• The wire which is coloured GREEN & YELLOW
must be connected to the terminal in your plug
which is marked with an E or by the EARTH
SYMBOL or coloured GREEN or GREEN &
YELLOW.
• The wire coloured BLUE is the NEUTRAL and
must be connected to the terminal in your plug
which is marked N or coloured BLACK.
• The wire coloured BROWN is the LIVE and must
be connected to the terminal in your plug which is
marked L or coloured RED.
• If any other plug is used, a 13 amp fuse must be fitted
either in the plug or adaptor or at the distributor
board.
CONNECTION TO THE MAINS SUPPLY
15