Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Before operating the unit for the first time, it is necessary to install the batteries in the
remote controller.
OPERATING GUIDE MODEL: AMW 25, 30
Start air conditioner. Point the remote controller at the fan coil and press ON/OFF button.
Select the operational mode. Press either "Cool", "Dry" or "Vent" button to select the desired
mode.
Set temperature. Press "+" or "-" button to set desired temperature.
Select fan speed. Press "Fan" button to select desired fan speed.
Set airflow position. Press "Vane" button to adjust airflow direction or to set vane to auto
swing.
Set Timer. If required, press "Time" button to set timer On or Off. After pressing "Time"
button, the Time display on the LCD will start to flash. Press "+" or "-" to set the time before
flashing stops.
Sleep mode. Select sleep mode by pressing "Time:" button until "Sleep" appears on the LCD
display. Sleep mode allows the air conditioner to raise the room temperature by up to 2°F from
set temperature while you sleep to save power.
Batteries are located at the back of the
remote controller (Model AMW25, 30) and
at the front of the remote controller (Model
AMW45, 60).
Open the battery holder by simultaneously
pushing downwards and inwards at the
area marked "OPEN"
Use only "AAA" alkaline batteries
Dispose of used batteries correctly, in a
manner not causing pollution or harm to the
environment.
Hide quick links:
Advertisement
Table of Contents
