Table of Contents
Advertisement
DVD-LS91EE / DVD-LS91GN / DVD-LS91GCS
9.3.
Service Mode Table 1
The service modes can be activated by pressing various button combination on the player and remote control unit.
Player buttons
Remote control unit buttons
PAUSE
+
PLAY
PAUSE
BWD-SKIP
PLAY
9.4.
DVD Self Diagnostic Function-Error Code
<Displayed during normal operations>
Error code
Contents
U11
Focus Servo error
CHECK DISK
U15
DVD-R not finalized
U70-1
HDMI/DVI EDID reading error Occurs when connection is HDMI/DVI and EDID data for
U70-2
HDMI/DVI
compliance
U70-3
HDMI/DVI authentication error Occurs when connection is HDMI/DVI and authentication of
H01
Tray loading error
H02
Spindle error
H03
Traverse motor error
H05
Seek time out error
H07
Driver IC thermal shutdown
0
Displaying the UHF display F_ _ _
5
Jitter check, tilt adjustment
*Display shows xx_yyyzz
"xx" and "zz" shown to the right have nothing to do with the jitter
value. "xx" is the error counter, while "zz" is the focus drive value.
Refer to section 11.4. for Optical Pickup Tilt Adjustment
Procedure.
6
Checking the region numbers and broadcast system
7
Checking the program version
9
Lighting Confirmation Function of Display Tube
DISPLAY
Checking the laser drive current
PAUSE
Writing the laser drive current value after replacing the optical
pickup (do not use for anything other than optical pickup
replacement)
The user setting is returned to the state of the factory shipment. Refer
—
Case of Occurrence
Dirty disc
Incompatible media
DVD-R and RW not finalized.
Output may result when a pickup error occurs.
the picture receiver cannot be read.
non-HDCP
Occurs when connection is HDMI/DVI and the picture
receiver is not compliant with HDCP.
HDCP:Copyright protection technology
Digital video signal encryption method
the picture receiver (using HDCP) failed.
Tray movement error. Unable to open. Unable to close.
Spindle motor errorFG pulse abnormal. Cable cut, etc.
Traverse abnormal
Unable to access. TOC reading error, etc.
Pickup error, disc error, etc.
Output results when a dirty disc is used.
Spindle motor error (short circuit in between brushes)
(Applicable to brush-type spindle motors only)
Application
24
Note
Refer to section 9.4. Self-
Diagnosis Function (UHF
Display).
Refer to section 11.4.
Optical
Pickup
Adjustment
Check the IC3001 FLASH
ROM program.
Refer
to
section
Optical
Pickup
Replacement Procedure.
to
section
Initializing
the
player.
Task
Remarks
Servo
U11 may also result when
DVD-R is not finalized.
Servo
Servo
AV
AV
AV
Panel
When OPEN:
FOPEN->CLOSE->OPEN-
>H01
When CLOSE:
FCLOSE->OPEN->CLOSE-
>H01
Servo
Servo
Servo
Changed to U11 from D80
series onward.
Servo
Tilt
8.5.
9.6.
DVD
Advertisement
Table of Contents
