Storage; Storing The Device; Longer Storage; Restarting - Honda AS 65 4T Operating Instructions Manual

Storage

Storing the device

Keep the device in a closed, dry, and well
ventilated room and out of reach of children.
Always eliminate all problems of the device
before you store it so that the device is always
in a safe-to-operate state. Let the engine cool
down before you store the device in closed
rooms.
Also observe the notices on storage in the
attached operating instructions by the engine
manufacturer.

Longer storage

1. Observe the safety instructions regarding
the handling of fuel.
2. Draining fuel tank: Put a piece of a tube on
the fuel valve and fill the fuel in an ade-
quate fuel container.
3. Emptying carburetor: Start the engine and
let it run until it stops on its own.
4. Clean the device thoroughly.
5. Touch up defects in painting (for spray
paint, see Accessories).
6. Performing corrosion protection on the
engine:
– Unscrew the spark plug.
– Fill a tablespoon of engine oil into the
spark plug opening.
– Pull the starter rope slowly until you get
resistance (oil distribution in the cylin-
der).
– Re-insert the spark plug and screw in
fully.
– Do not fit the spark plug connector!
In autumn, have your device checked by an
authorised service centre!
Also observe the notices on storage in the
attached operating instructions by the engine
manufacturer.
22

Restarting

If you want to start the device after a longer
storage, carry out the tasks described in chap-
ter Maintenance.
leer er Abs atz

Spare parts

The reliable and safe operation of the device
also depends on the quality of the spare parts
used. Only use original spare parts and acces-
sories that were approved by
"AS-Motor Germany". When foreign parts are
installed, the warranty and guarantee shall be
void for the foreign part and for the device and
for any resulting damage.
Inform your authorised service centre about
the device type and serial number of your
devices when you order spare parts.
leer er Abs atz

Wear parts

Some parts are wear parts. They wear during
use and must be replaced. The warranty does
not cover the following parts:
Blades, cutting blades, cutter bars, blade bolts,
sliding plates, V-belt, chains, Bowden cables,
starter ropes, pressure plates, air filters, spark
plugs, disc springs, lock washers, fuses, discs,
thrust plates, pressure discs, protection skirts,
impact protection, wheels, tires.
leer er Abs atz

Disposal

The device cuts and shreds the plant material
in a single operation. Shredded plant material
decomposes quickly, can be utilized as fertiliz-
er, and, therefore, be left on the ground.
Dispose of waste oil and fuel in accordance
with the local regulations or return it to an oil
shop.
Packaging, device, and accessories are made
of recyclable materials and must be disposed
of accordingly.