Basic Weighing - Accurist W3300 Series Operating Manual

The display on the balance has a backlight, and an internal timer will turn off the
backlight (power-save mode) if the balance is not used for a period of time. The
default time delay for back light shut off is one minute, and this time is adjustable by
following these instructions:
Hold the PRINT button and then simultaneously press the % PERCENT button.
This will put the display into the settings mode.
Press the TARE button repeatedly until the display shows "bLI9h7" which
indicates Back LIGHT timer setting. Then press ENTER to choose it.
The display will show the current setting of delay for the backlight to remain on
when the balance is inactive, before shutting off.
For example: "1 nIn " on the diplay means 1 minute.
Press TARE repeatedly to toggle through the choices of the delay time.
Press ENTER to choose the value. Now the backlight timer is set to the new value.
Display Information
OK: Weight reading shown is stable.
g
: Weight reading is shown in grams.
Oz: Weight reading is shown in ounces
Ct: Weight reading is shown in carats
%: Reading shown is given in as a percent weight (see Percent Deviation Mode)
PCS: Reading shown is given in number of pieces (see Count Mode)
UNABLE: Operational Error
HHHHHH: The weight exceeds the capacity of the balance.
LLLLLL: The pan is not properly seated or has been removed.

3-2 Basic weighing

Plug in the balance using the included power supply, the balance will turn
1.
on and go through the initial testing. Once completed, the display will
read 0.00g
Place a weigh boat or weighing container on the weighing pan
2.
Press the TARE key and wait for the display to show 0.00g
3.
7