16-28 ELECTRICAL SYSTEM
Secure the alternator lead with a holding plate, and apply
a non-permanent locking agent to the threads of the plate
bolts and tighten them.
Torque - Alternator Lead Holding Plate Bolts: 6.9 N·m (0.70
kgf·m, 61 in·lb)
Install the alternator cover (see Alternator Cover Installa-
Alternator Rotor Removal
Alternator Cover (see Alternator Cover Removal)
Starter Idle Gear and Shaft
Wipe oil off the outer circumference of the rotor.
Hold the alternator rotor steady with the flywheel holder
[A], and remove the rotor bolt [B].
Special Tool - Flywheel Holder: 57001-1313
Using the flywheel puller [A], remove the alternator rotor
from the crankshaft.
Special Tool - Flywheel Puller, M38 × 1.5: 57001-1405
Do not attempt to strike the alternator rotor itself.
Striking the rotor can cause the magnets to lose
Alternator Rotor Installation
Using a cleaning fluid, clean off any oil or dirt on the fol-
lowing portions and dry them with a clean cloth.
Crankshaft Tapered Portion [A]
Alternator Rotor Tapered Portion [B]
Apply a thin coat of molybdenum disulfide grease to the
Install the starter gear [A] and washer [B].
Again, clean the crankshaft tapered portion [C] and dry