11-10 FINAL DRIVE
Engine Sprocket Removal
Engine Sprocket Cover Bolts [A]
Engine Sprocket Cover [B]
Flatten out the bended washer [A].
Remove the engine sprocket nut [B] and washer.
When loosening the engine sprocket nut, hold the rear
Raise the rear wheel off the ground.
Remove the axle cotter pin, and loosen the rear axle nut.
Loosen the both chain adjuster locknut to loosen the drive
Remove the drive chain from the rear sprocket toward the
Pull the engine sprocket [A] with drive chain [B] off the
output shaft [C].
Disengage the drive chain from the engine sprocket.
Engine Sprocket Installation
Replace the engine sprocket washer and axle cotter pin.
Install the engine sprocket onto the shaft so that the mark
side [A] faces outwards.
Apply molybdenum disulfide oil to the threads of the out-
put shaft and the seating surface of the engine sprocket
After torquing the engine sprocket nut, bend the one side
of the washer [B] over the nut.
Tighten the nut while applying the rear brake.
Torque - Engine Sprocket Nut: 127 N·m (13 kgf·m, 94 ft·lb)
Adjust the drive chain slack after installing the sprocket
(see Drive Chain Slack Adjustment in the Periodic Main-