Support the engine with a suitable stand.
Put a plank onto the suitable stand for engine balance.
Install the engine mounting bolts and nuts, following the
specified installing sequence.
First, install the adjusting collars [A] to backside of the
upper and lower crankcase and right side of the frame.
Second, hang the drive chain over the output shaft just be-
fore moving the engine into its final position in the frame.
Third, install the bolts [A] [B] [C] [D] temporarily.
Fourth, tighten the lower [A] and middle [B] engine mounting bolts counterclockwise.
Tighten the bolts until the clearance between the engine and collar come to 0 mm (0 in.).
Torque - Lower Engine Mounting Bolt: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Middle Engine Mounting Bolt: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Fifth, tighten the left upper engine mounting bolt [D].
Torque - Left Upper Engine Mounting Bolt: 44 N·m (4.5 kgf·m, 33 ft·lb)
Sixth, tighten the lower [E] and middle [F] engine mounting nuts.
Torque - Lower Engine Mounting Nut: 44 N·m (4.5 kgf·m, 33 ft·lb)
Middle Engine Mounting Nut: 44 N·m (4.5 kgf·m, 33 ft·lb)
Seventh, pull out the bolt [C] temporarily, and tighten the adjusting collar [G] counterclockwise until
the clearance [H] between the cylinder head and collar come to 0 mm (0 in.).
Eighth, tighten the right upper engine mounting bolt [C].
Torque - Right Upper Engine Mounting Bolt: 44 N·m (4.5 kgf·m, 33 ft·lb)
Ninth, tighten the adjusting collar locknut [I].
Special Tool - Engine Mount Nut Wrench: 57001-1450
Torque - Adjusting Collar Locknut: 49 N·m (5.0 kgf·m, 36 ft·lb)
ENGINE REMOVAL/INSTALLATION 8-7