3-112 FUEL SYSTEM (DFI)
Fuel Tank and Cap Inspection
Visually inspect the gasket [A] on the tank cap for any
Replace the gasket if it is damaged.
Check to see if the water drain pipe [B] and fuel breather
pipe [C] (California Model) in the tank are not clogged.
Check the tank cap breather also.
If they are clogged, remove the tank and drain it, and then
blow the breather pipe with compressed air.
Do not apply compressed air to the air vent holes
[D] in the tank cap. This could cause damage and
clogging of the labyrinth in the cap.
Fuel Tank Cleaning
Clean the tank in a well-ventilated area, and take
care that there are no sparks or flame anywhere
near the working area. Because of the danger or
highly flammable liquids, do not use gasoline or
low-flash point solvents to clean the tank.
Remove the fuel tank (see Fuel Tank Removal).
Remove the fuel pump (see Fuel Pump Removal).
Pour some high-flash point solvent into the fuel tank and
shake the tank to remove dirt and fuel deposits.
Draw the solvent out of the fuel tank.
Dry the tank with compressed air.
Install the fuel pump (see Fuel Pump Installation).
Install the fuel tank (see Fuel Tank Installation).