Fuel Tank Installation
Note the above WARNING (see Fuel Tank Removal).
Route the hoses correctly (see Cable, Wire, and Hose
Routing section in the Appendix chapter).
For California Model, note the following.
To prevent the gasoline from flowing into or out of the
canister, hold the separator perpendicular to the ground.
Connect the hoses according to the diagram of the sys-
tem (see Cable, Wire, and Hose Routing section in the
Appendix chapter). Make sure they do not get pinched or
Route the hoses with a minimum of bending so that the
air or vapor will not be obstructed.
Pull [A] the joint lock as shown.
Insert the fuel hose joint [A] straight onto the delivery pipe
until the hose joint clicks.
Push the joint lock [B] until the hose joint clicks.
Push and pull the hose joint [A] back and forth more than
two times and make sure it is locked and doesn't come
off. When the hose joint is correctly installed, it should
slide on the delivery pipe about 5 mm (0.2 in.).
Make sure the hose joint is installed correctly on the
delivery pipe by sliding the joint, or the fuel could
If it does not slide, reinstall the hose joint.
Connect the fuel pump connector and the battery (–) lead
FUEL SYSTEM (DFI) 3-111