Set the dimmer switch to high beam position.
The low beam [A] and high beam [B] headlights should
The high beam indicator LED [C] should go on.
If the high beam headlight and/or high beam indicator LED
does not go on, inspect or replace the following item.
Headlight High Beam Bulb (see Electrical System chap-
Dimmer Switch (see Electrical System chapter)
Turn off the engine stop switch.
The low beam and high beam headlights should stay go-
If the headlights and high beam indicator LED does go
off, inspect or replace the following item.
Headlight Relay in Relay Box (see Electrical System
Turn off the ignition switch.
The headlights and high beam indicator LED should go
Headlight Aiming Inspection
Inspect the headlight beam for aiming.
If the headlight beam points to one side rather than
straight ahead, adjust the horizontal beam.
Headlight Beam Horizontal Adjustment
Turn the horizontal adjuster [A] in both headlights in or out
until the beam points straight ahead.
If the headlight beam points too low or high, adjust the
Headlight Beam Vertical Adjustment
Turn the vertical adjuster [B] in both headlights in or out
with a screwdriver to adjust the headlight vertically.
PERIODIC MAINTENANCE 2-39