Installation - Electrolux EKK925A0 User Manual

24 www.electrolux.com
Problem
The lamp does not oper‐
ate.
Steam and condensation
settle on the food and in
the cavity of the oven.
The oven does not heat
up.
The oven does not heat
up.
The turnspit does not ro‐
tate.
It takes too long to cook
the dishes or they cook too
quickly.
The display shows an error
code that is not in this ta‐
ble.
The display shows "12.00". There was a power cut.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

14. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
The lamp is defective.
You left the dish in the
oven for too long.
The clock is not set.
The necessary settings are
not set.
The turnspit is not correctly
installed into the turnspit
hole.
The temperature is too low
or too high.
There is an electrical fault.
plate is on the front frame of the
appliance cavity. Do not remove the
rating plate from the appliance cavity.
.........................................
.........................................
.........................................
Remedy
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Set the clock.
Make sure that the settings
are correct.
Refer to "Using the turn‐
spit".
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
Deactivate the oven with
the house fuse or the safe‐
ty switch in the fuse box
and activate it again.
If the display shows the er‐
ror code again, contact the
Customer Care Depart‐
ment.
Reset the clock.