Rs232 Commands Over The Network - Asus ST467 User Manual

RS232 commands over the network

The display also supports extending access to the RS232 commands over a network
connection. Below are the steps to follow for controlling the display over LAN through the
RJ45 connector.
1. Connect display & PC to hub or connect display to PC with LAN cable directly.
2. Set display IP address. (See "Connecting the display to a local area network" on page
26)
3. Commands are sent via TCP connection to port 4660. The commands are the same as
for the RS232 port.
4. You can test commands using any TCP utility program that allows you to enter binary
data in hexadecimal format.
Network connection 35