Cancelling Alarms From Memory; Test Cycle; Disabling / Enabling Pulse Washing - Electrolux DIVA 60 cm Service Manual

9.3 Cancelling alarms from memory

Every alarm should be cancelled after it has been read and after the appliance has been repaired.
When the next diagnostic test is run, this will enable the serviceman to know whether the alarm has
occurred again.
To cancel alarms:
1. Access the diagnostic mode (see 9.1)
2. Press button Options repeatedly until the following message appears on the display:
3 LED TEST
3. Press button Ok/Start to confirm
All the LEDs and the display flash for around 30 seconds
The buzzer sounds repeatedly for around 30 seconds
4. This function ends automatically with the machine setting itself to the cycle selection mode.

9.4 Test cycle

The test cycle is a shortened wash programme for use by service personnel only. It can be used to
test all the functions in a traditional washing cycle. In effect, a normal cycle is simulated.
To run the test cycle:
1. Access the diagnostic mode (see 9.1)
2. Press button Options repeatedly until the following message appears on the display:
4 LINE TESTS alternating with NO. OF CYCLES XX
3. To start the cycle:
Press button Options
4. The programme starts:
The programme runs like a normal cycle, complete with all phases
All pause and cancellation functions are available
Phase
Water fill, Turbo enabled
Water fill
Pulse washing, dispenser
opens
Drain
Water fill
Pulse washing
Drain
Water fill
Controlled washing at 2800
RPM, heating to 60°C
Controlled washing at 2800
RPM, temp. maintained at 60°C
•
The total duration of the cycle is about 50 minutes.
•
The resins are washed at the beginning of the first programme executed after the test cycle.

9.5 Disabling / enabling pulse washing

Some programmes use a pulse washing (PW) system. The following procedure can be used to
modify this system by substituting continuous washing «Ctrl» in all cycles where «PW» pulse washing is the
default. This modification enhances washing action, even in delicate programmes.
To modify the wash cycle by disabling pulse washing:
1. Access the diagnostic mode (see 9.1)
2. Press button Options repeatedly until the following message appears on the display:
PULSE WASHING YES (when SI flashes, pulse washing is enabled)
3. Press button Ok/Start to toggle the setting
The word NO appears on the display (pulse washing is disabled)
4. To confirm:
Press button Options
OR wait 60 seconds
OR turn the appliance off by pressing button S0
Duration
Temperature
30''
25''
45''
dilution
---
60''
dilution
---
1200''
33
Time