Pentax K-m/K2000 Operating Manual page 259

Problem
The USB
connection
The USB
with a printer
Connection is set to
does not
[PC]
work
properly
The Shake
Reduction function
is off
The Shake
Reduction function
is not set properly
Shake
Reduction
Shutter speed is too
does not
low for the Shake
work
Reduction function
to be effective when
panning or shooting
night scenes, etc.
The subject is too
close
In rare cases, the camera may not operate correctly due to static electricity.
This can be remedied by taking the batteries out and putting them back in
again. When the mirror remains in the up position, take the batteries out and
put them back in again. Then, turn the power on. The mirror will retract. After
the procedure is done, if the camera operates correctly, it does not require any
repairs.
Cause
Set [USB Connection] in the [R Set-up 2]
menu to [PictBridge]. (p.204)
Turn on the Shake Reduction function.
(p.122)
If a lens for which focal length information
cannot be acquired is used, set the [Focal
Length] on the [Input Focal Length] menu.
(p.124)
Turn off the Shake Reduction function and
use a tripod.
Move away from the subject, or turn off the
Shake Reduction function and use a tripod.
Remedy
257
12