GE N60 Instruction Manual page 161

5 SETTINGS
The fixed GOOSE settings are shown below:

PATH: SETTINGS PRODUCT SETUP
 
TRANSMISSION FIXED GOOSE
 FIXED GOOSE

MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
These settings are applicable to fixed (DNA/UserSt) GOOSE only.
The setting represents the IEC 61850 GOOSE application ID (GoID) name string sent as part of each GOOSE
GOOSE ID
message. This string identifies the GOOSE message to the receiving device. In revisions previous to 5.0x, this name string
was represented by the
RELAY NAME
The setting allows the destination Ethernet MAC address to be set. This address must be a multicast
DESTINATION MAC
address; the least significant bit of the first byte must be set. In N60 releases previous to 5.0x, the destination Ethernet
MAC address was determined automatically by taking the sending MAC address (that is, the unique, local MAC address of
the N60) and setting the multicast bit.
The setting indicates the Ethernet priority of GOOSE messages. This allows GOOSE messages to
GOOSE VLAN PRIORITY
have higher priority than other Ethernet data. The
ID for each GOOSE sending device. This value can be left at its default if the feature is not required. Both the
and
PRIORITY GOOSE ETYPE APPID
GE Multilin N60 Network Stability and Synchrophasor Measurement System
 
COMMUNICATIONS IEC 61850 PROTOCOL
GOOSE FUNCTION:
Disabled
GOOSE ID:
GOOSEOut
DESTINATION MAC:
000000000000
GOOSE VLAN PRIORITY:
4
GOOSE VLAN ID:
0
GOOSE ETYPE APPID:
0
setting.
GOOSE ETYPE APPID
settings are required by IEC 61850.
5.2 PRODUCT SETUP

GSSE/GOOSE CONFIGURATION
Range: Enabled, Disabled
Range: 65-character ASCII string
Range: standard MAC address
Range: 0 to 7 in steps of 1
Range: 0 to 4095 in steps of 1
Range: 0 to 16383 in steps of 1
setting allows the selection of a specific application
5
GOOSE VLAN
5-43