GE N60 Instruction Manual page 154

5.2 PRODUCT SETUP
When a 0 value is involved in a change, the changes to the
N60 is restarted.
NOTE
Do not set more than one protocol to the same TCP/UDP port number, as this results in unreliable operation of
those protocols.
i) PROTOCOL
The Protocol menu setting allows selection of one of the following protocols: DNP 3.0, IEC60870-104, or IEC60870-103.
For any change to take effect, restart the unit.
The table shows which of DNP 3.0, IEC 60870-5-104, IEC 60870-5-103, and IEC 61850 protocols are operational on the
RS232, RS485, and Ethernet ports. It shows all possible combinations of the
tings.
Table 5–5: PORT AND PROTOCOL COMBINATIONS
PROTOCOL DNP CHANNEL 1(2) PORT
SETTING SETTINGS
DNP Channel 1: Eth TCP
Channel 2: Eth TCP
Channel 1: Eth TCP
Channel 2: none
5
Channel 1: none
Channel 2: Eth TCP
Channel 1: Eth UDP
Channel 2: none
Channel 1: Eth TCP
Channel 2: RS485
Channel 1: Eth TCP
Channel 2: RS232
Channel 1: Eth UDP
Channel 2: RS485
Channel 1: Eth UDP
Channel 2: RS232
Channel 1: RS485
Channel 2: Eth TCP
Channel 1: RS232
Channel 2: Eth TCP
Channel 1: RS485
Channel 2: RS232
Channel 1: RS232
Channel 2: RS485
Channel 1: RS485
Channel 2: none
IEC 104
IEC 103
5-36
RS232
Modbus
Modbus
Modbus
Modbus
Modbus
DNP
Modbus
DNP
Modbus
DNP
DNP
DNP
Modbus
Modbus
Modbus
N60 Network Stability and Synchrophasor Measurement System
MODBUS TCP PORT NUMBER
PROTOCOL
RS485 ETHERNET
Modbus DNP, Modbus, IEC 61850
Modbus DNP, Modbus, IEC 61850
Modbus DNP, Modbus, IEC 61850
Modbus DNP, Modbus, IEC 61850
DNP DNP, Modbus, IEC 61850
Modbus DNP, Modbus, IEC 61850
DNP DNP, Modbus, IEC 61850
Modbus DNP, Modbus, IEC 61850
DNP DNP, Modbus, IEC 61850
Modbus DNP, Modbus, IEC 61850
DNP Modbus, IEC 61850
DNP Modbus, IEC 61850
DNP Modbus, IEC 61850
Modbus IEC 104, Modbus, IEC 61850
IEC 103 Modbus, IEC 61850
5 SETTINGS
setting take effect when the
and set-
DNP CHANNEL 1(2) PORT
GE Multilin