GE N60 Instruction Manual page 106

4.3 FACEPLATE INTERFACE
1. Bend the tabs at the left end of the tool upwards as shown below.
2. Bend the tab at the center of the tool tail as shown below.
4
The following procedure describes how to remove the LED labels from the N60 enhanced front panel and insert the custom
labels.
1. Use the knife to lift the LED label and slide the label tool underneath. Make sure the bent tabs are pointing away from
the relay.
4-18 N60 Network Stability and Synchrophasor Measurement System
4 HUMAN INTERFACES
GE Multilin