AEG BS836680F User Manual page 62

62 www.aeg.com
b) An acoustic signal sounds when
c) Touch the display to deactivate
Steam Cleaning Plus - the duration
of the function is around 75 minutes.
a) Spray a suitable detergent
b) Activate the function.
c) Wipe the internal surface of the
d) The final part of the procedure
3. Wipe the internal surface of the
appliance with a non-abrasive surface
care sponge. You can use warm
water to clean the cavity.
4. Remove the remaining water from
the water drawer.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. To speed up the
drying you can heat up the appliance
with hot air at temperature 150 °C for
approximately 15 minutes. You can get
maximum effects of the cleaning function
if you manually clean the appliance
immediately after the function ends.
12.5 Cleaning Reminder
This function reminds you that the
cleaning is necessary and that you should
perform the function: Steam Cleaning
Plus.
EURO Appliances - euappliances.info
the programme is completed.
the signal.
uniformly in the oven cavity on
both enamel and steel parts.
Before you start the cleaning
procedure, make sure that the
appliance is cold.
After around 50 minutes an
acoustic signal sounds when the
first part of the programme is
completed.
This is not the end of
the cleaning
procedure. Follow
the message in the
display to complete
the cleaning.
appliance with a non-abrasive
surface care sponge. You can use
warm water or oven detergents
to clean the cavity.
starts. The duration of this stage
is around 25 minutes.
You can enable / disable the function:
Cleaning Reminder in the menu: Basic
Settings.
12.6 Cleaning the water
drawer
Remove the water drawer from the
appliance.
1. Remove the lid of the water drawer.
Lift the cover in correspondence with
the protrusion in the rear.
M
A
X
2. Remove the wave-breaker. Pull it
away from the drawer body until it
snaps out.
3. Wash the water drawer parts with
your hands. Use tap water and soap.
Do not use abrasive
sponges. Do not put
water drawer inside a
dish washer.
After you clean the water drawer parts,
reassemble the water drawer.
1. Snap in the wave-breaker. Push it
into the drawer body.
2. Assemble the lid. First insert the front
snap and then push it against the
drawer body.
M
A
X
M
A
X
3. Insert the water drawer inside the
appliance.
4. Push the water drawer towards the
oven until it latches.