Table of Contents
Advertisement
To Replace Keypad Label Assembly
1. Discontinue electrical power to the dryer.
2. Repeat step 1-5 for computer board removal.
3. Slowly peel off and remove keypad label assembly from control
panel.
4. Peel paper backing off new keypad label assembly.
5. Holding the new keypad label assembly close to the panel,
insert the keypad ribbon through the rectangular slot in the
control panel. Align label assembly into position by matching
the clear viewing window on the label to the rectangular cutout
in the panel and gently press into place.
6. Reverse the above procedure.
Reestablish electrical power to the dryer.
To Replace Microprocessor Temperature Sensor Probe
1. Discontinue electrical power to the dryer.
2. Remove lint drawer. Remove two screws
securing lint door stop and remove lint draw.
3. Loosen the on 5/16 Pal Nut securing bracket
assembly to the dryer and remove bracket
from dryer.
4. Disconnect sensor bracket harness connector.
5. Remove microprocessor sensor bracket
assembly from the dryer.
6. Install new sensor probe assembly (P/N
836028) by reversing procedure.
7. Reestablish electrical power to the dryer.
NOTE: If, when power is reestablished,
the computer display reads
exhaust probe fault check for a
loose connection in the wiring.
450362 - 1
Maytag Co.
15
Hide quick links:
Advertisement
Table of Contents
