Programming Homelink - GMC Chevrolet SSR 2003 Owner's Manual

Programming HomeLink

Your vehicle's engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1. Press and hold down the two outside buttons,
releasing only when the indicator light begins to
flash, after 20 seconds. Do not hold down the
buttons for longer than 30 seconds and do not
repeat this step to program a second and/or third
transmitter to the remaining two HomeLink
2. Position the end of your hand-held transmitter about
1 to 3 inches (3 to 8 cm) away from the HomeLink
buttons while keeping the indicator light in view.
3. Simultaneously press and hold both the desired
button on HomeLink
button. Do not release the buttons until Step 4
has been completed.
Some entry gates and garage door openers may
require you to substitute Step 3 with the procedure
noted in "Gate Operator and Canadian
Programming" later in this section.
2-28
®
®
®
and the hand-held transmitter
4. The indicator light will flash slowly at first and then
rapidly after HomeLink
frequency signal from the hand-held transmitter.
Release both buttons.
5. Press and hold the newly-trained HomeLink
and observe the indicator light.
If the indicator light stays on constantly,
programming is complete and your device should
activate when the HomeLink
released.
buttons.
To program the remaining two HomeLink
begin with Step 2 under "Programming HomeLink
®
Do not repeat Step 1 as this will erase all of the
programmed channels.
If the indicator light blinks rapidly for two seconds
and then turns to a constant light, continue with
Steps 6 through 8 following to complete the
programming of a rolling-code equipped device
(most commonly, a garage door opener).
®
successfully receives the
®
button
®
button is pressed and
®
buttons,
®
."