Sony NWZ-S515 Service Manual page 73

6. Click OK button.
7. Click OK button.
8. Click OK button.
9. Updating process starts.
10. Click Finish button and update is completed.
5. Use of the LCD Confi g Setting Tool
Note: When you use the LCD Confi g Setting Tool, quit the SonicStage.
Procedure:
1. the LCD sub assy (LCD801) is replaced.
2. The power supply of main unit is turned on, and it connects it
with PC.
Note: In this state, main unit of the state of energizing is not displayed to
anything in LCD.
3. Command Prompt is started, and move to the folder where the
data that wants to be written is stored.
• When model is NWZ-S515/S516, and the LCD sub assy
(LCD801) in change parts is made of EPSON:
cd c:\LCD_EPSON\NWZ_S51X
• When model is NWZ-S515/S516, and the LCD sub assy
(LCD801) in change parts is made of TMD:
cd c:\LCD_TMD\NWZ_S51X
• When model is NWZ-S615F/S616F/S618F, and the LCD sub
assy (LCD801) in change parts is made of EPSON:
cd c:\LCD_EPSON\NWZ_S61X
NWZ-S515/S516/S615F/S616F/S618F
• When model is NWZ-S615F/S616F/S618F, and the LCD sub
assy (LCD801) in change parts is made of TMD:
cd c:\LCD_TMD\NWZ_S61X
Fig. 1 Directory change (When model is NW-S615F/
S616F/S618F, and the LCD sub assy (LCD801) in
change parts is made of TMD)
4. Input "updating-mtp" and press the Enter key.
Fig. 2 Update tool start
5. Message of Fig.3 is displayed, input "y" and press the Enter
key.
Fig. 3 Update confi rmation screen
6. Message of Fig.4 is displayed. Then, LCD_Confi g-data-copy-
operation starts.
Fig. 4 Writing of LCD_Confi g data
7. The main unit reboots automatically after LCD_Confi g data is
updated.
After rebooting, check that Connecting USB (MTP) is dis-
played on LCD of the main unit.
8. Input "EXIT" to close Command Prompt.
Note: Change the setting of LCD_Confi g again according to the same
procedure when the LCD sub assy (LCD801) connected with the
main board and the LCD_Confi g data on the main board is not
corresponding.
3