Download Print this page
Pelonis HC-0119A Owner's Manual
Pelonis HC-0119A Owner's Manual

Pelonis HC-0119A Owner's Manual

Tower ceramic heater

Advertisement

MANUAL
Tower Ceramic
PLEASE READ AND SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
OWNER'S
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
3. Extreme caution is necessary when any heater is used by or near children or invalids
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
9. To disconnect heater, first turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
12. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where
13. Use this heater only as described in this manual. Any other use not recommended by
14. Avoid the use of an extension cord because the extension cord may overheat and
Heater
With Remote
15. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do
16. It is normal for the plug to feel warm to the touch; however, a loose fit between the AC
Model: HC-0119A
17. The output of this heater may vary and its temperature may become intense enough to
18.
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
If provided, use handles when moving this heater. Keep combustible materials, such
as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from
the front of the heater and keep them away from the sides and rear.
and whenever the heater is left operating and unattended.
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment, or
repair.
locations. Never locate heater where it may fall into bathtub or other water container.
coverings. Arrange cord away from traffic area and where it will not be tripped over.
may cause an electric shock or fire, or damage the heater.
use on soft surfaces, like a bed, where openings may become blocked.
gasoline, paint, or flammable liquids are used or stored.
the manufacturer may cause fire, electric shock, or injury to persons.
cause a risk of fire. However, if you have to use an extension cord, the cord shall be
No. 14 AWG minimum size and rated no less than 1875 watts.
not plug the heater into a circuit that already has other appliances working.
outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn outlet.
burn exposed skin. Use of this heater is not recommended for persons with reduced
sensitivity to heat or an inability to react to avoid burns.
"SAVE THESE INSTRUCTIONS"

Advertisement

loading
Need help?

Need help?

Do you have a question about the HC-0119A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Pelonis HC-0119A

  • Page 1 16. It is normal for the plug to feel warm to the touch; however, a loose fit between the AC Model: HC-0119A outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.
  • Page 2 UNPACKING AND SET-UP INSTRUCTIONS Unpack your heater and remove both halves of the base from the package. Refer to the picture below: Make sure the heater is unplugged and in the “ OFF” position. TURN THE HEATER UPSIDE DOWN. Unfasten the four screws. both halves of the base as shown.
  • Page 3  Pack the heater in the original carton and store it in a cool and dry place. SPECIFICATIONS Model No.: HC-0119A Voltage: 120V, 60Hz Current: Maximum continuous draw: 12.5 Amps. Power: LO = 900 Watts, HI = 1500 Watts.
  • Page 4 PELONIS warrants as limited herein to the original purchaser of retail that each new Pelonis Tower Ceramic Heater shall be free of defects in material and workmanship for a period of one (1) year from the date of original purchase. This one (1) year warranty is limited to the heating elements, motor, and electric control circuit board.