Pause Insertion - Panasonic KX-TDA100D Features Manual

1.5.4 Trunk Call Features

1.5.4.7 Pause Insertion

Description
Pressing a PAUSE button inserts a preprogrammed Pause time between digits of a user-dialled number before
the number is dialled out, allowing certain numbers separated with a pause to be used to access certain
features (e.g., access codes, seizing idles lines, etc.).
When a pause is needed, pauses must be inserted manually (pressing the PAUSE button) in all cases, except
for the following access codes where a pause is automatically inserted between the user-dialled access code
and the subsequent digits:
a.
Host PBX Access code (® 1.5.4.8 Host PBX Access Code (Access Code to the Telephone Company
from a Host PBX))
b.
Special Carrier Access code (® 1.5.4.9 Special Carrier Access Code)
c.
Second Dial Tone Waiting code
Conditions
•
The Pause time is programmable for each trunk.
•
Pauses can be stored in Memory Dialling.
•
When a Second Dial Tone Waiting code is dialled after seizing a trunk, a preprogrammed number of pauses
are inserted after the code.
•
ARS
A pause is not automatically inserted between the user-dialled access code and the subsequent digits
when the ARS mode is enabled. (1.10.1 Automatic Route Selection (ARS))
PC Programming Manual References
3.10 [1-1] Slot—Port Property - LCO Port—
3.18 [1-1] Slot—Port Property - T1 Port—
3.24 [1-1] Slot—Port Property - E1 Port—
3.27 [1-1] Slot—Port Property - EM Port—
3.30 [1-1] Slot—Port Property - DID Port—
4.4 [2-3] Timers & Counters—Miscellaneous—
8.4 [6-4] Second Dial Tone
PT Programming Manual References
[416] LCOT Pause Time
94 Feature Guide
Pause Time
Pause Time
Pause Time
Pause Time
Pause Time
During Conversation—Pause Signal Time