Page 2
Tools that may be required for installation: (not furnished) 1. Pliers. 2. Wire ties (for securement). Part illustrations: A. Fold back hook (outside fastener). B. Fingertip hook (inside fastener).
Page 3
Note: There is no designated Left or Right chain. Either chain may be used for either tire. this side facing vehicle Position the side chain with the fingertip hook to go on the inside of the tire (toward body of the machine/vehicle).
Page 4
Grasping the middle of the inside fastener side chain, lift and drape the chain assembly over the tire, making sure the open ends of the cross chain hooks are facing away from the tire. Tuck the loose chain ends under the tire, then move the machine/vehicle forward slightly to be able to work with the fasteners.
Page 5
Pull chain snug and connect the outside fastener to its side chain the same number of links back from the end as the inside connection. Fold fastener back and under the side chain as pictured below. You will probably need pliers to do it.
Page 6
To get maximum wear and years of use from your Peerless “MaxTrac” tire chains follow these simple tips: Avoid rapid acceleration: spinning tires cause rapid wear on cross chains. If the chains are installed properly they should be snug with the cross chains at right angles to the side chain.