Table of Contents
Advertisement
Please carry out each step only in the order specified:
2.
Carefully insert the flat blade of the screwdriver from the vehicle tool kit in the direction of
the arrow into the slot in the license plate light ⇒
3.
Pull the license plate light out slightly.
Press the lock on the connector plug in the direction of the arrow ⇒
4.
5.
Turn the bulb holder in the direction of the arrow
6.
Replace the burned out light bulb with a new bulb of the same type.
7.
Insert the bulb holder in the license plate light assembly and turn it counterclockwise in the
8.
9.
Carefully Insert the license plate light back into the opening in the bumper. Make sure the
license plate light is installed in the correct direction.
10.
Press the license plate light assembly into the bumper until it latches with an audible "click."
Different models may have different lights, and the location and design of covers, bulb holders,
and bulbs may be in a different location than shown in the illustrations.
You cannot replace the LEDs in LED license plate lights. Contact your authorized Volkswagen
dealer or authorized Volkswagen Service Facility for assistance.
connector plug off.
direction of the arrow
(2)
Plug the connector plug back into the bulb holder.
f ig.
195.
f ig. 196 (1)
and pull the
(2)
and remove it with the bulb.
until it stops.
Advertisement
Table of Contents
