Siemens hicom 150 H optiset E standard Operating Instructions Manual page 65

6WHS#E\#6WHS
• Leave an advisory message,
code: 69/#69 (Æ page 59)
*
• Group ringing, code:
• Group call, code:
• Suppress caller ID,
code: 86/#86 (Æ page 25)
*
• Waiting tone, code:
• Open door, code:
• Door opener on/off, code:
• Control relay, code:
• Do not disturb, code:
• Ringer cutoff function, code:
• Speed-dialing, code:
• Associated service, code:
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
Set up a call to the system. Enter the station number
(contact System Support).
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
Enter the code (necessary only if programmed in the
system).
Wait for a dial tone and then enter the code, such as
97 for Do not disturb on. Make other inputs as neces-
*
sary; (refer to the operating instructions for pulse and
DTMF telephones).
or
Dial the external number.
You can only execute one function at a time, or
set up only one outgoing connection.
The connection is immediately released after
successful activation of a function.
In the case of an external-external call, the con-
nection is released as soon as either of the par-
ties ends the call.
8VLQJ#2WKHU#)XQFWLRQV
81/#81 (Æ page 76)
*
85/#85 (Æ page 76)
*
87/#87 (Æ page 15)
*
61 (Æ page 21)
*
89/#89 (Æ page 22)
*
90/#90 (Æ page 67)
*
97/#97 (Æ page 19)
*
98/#98 (Æ page 19)
*
7 (Æ page 39)
*
83 (Æ page 63)
*
98