Download  Print this page

Sprocket; Engine Sprocket Removal (klx250-h5 - H7, H6f -); Engine Sprocket Installation (klx250-h5 - H7, H6f -) - Kawasaki KLX250R Owner's Manual

D-tracker.
Hide thumbs

Advertisement

10-4 FINAL DRIVE
Sprocket
Engine Sprocket Removal (KLX250-H5 - H7, H6F -)
•Remove:
Bolts [AJ
Engine Sprocket Cover [BJ with Chain Guide
•Flatten out the bended washer [AJ.
•Remove:
Engine Sprocket Nut [BJ and Washer
NOTE
o
When loosing the engine sprocket nut, hold the rear
brake on.
•Loosen the drive chain.
• Remove the drive chain from the rear sprocket toward the
right.
•Pull the engine sprocket [AJ off the output shaft [BJ along
with the chain.
•Remove the engine sprocket.
Engine Sprocket Installation (KLX250-H5 - H7, H6F
-)
• Replace the sprocket washer.
•Install the engine sprocket onto the output shaft.
•Apply oil to the threads of the output shaft and the seating
surface of the engine sprocket nut.
• Engage the drive chain with the engine and rear sprocket.
•Tighten:
Torque - Engine Sprocket Nut: 125 N-m (13.0 kgf·m, 92 ft-lb)
NOTE
o
Tighten the nut while applying the rear brake.
• Bend the one side of the washer over the nut.
•Adjust the drive chain slack after installing the sprocket.
•Install the engine sprocket cover and tighten the bolts.
Torque - Engine Sprocket Cover Bolts: 9.8 N·m (1.0 kgf·m,
87 in-lb)

Advertisement

Table of Contents

   Also See for Kawasaki KLX250R

This manual is also suitable for:

Klx250

Comments to this Manuals

Symbols: 0
Latest comments: