Download  Print this page

Rear Wheel Installation - Kawasaki KLX250R Owner's Manual

D-tracker.
Hide thumbs

Advertisement

Wheels (Rims)
Rear Wheel Installation
•Fit the rear caliper stop [AJ to the swing arm stop [BJ.
•Install the collar and cap to both rear hub so that the pro-
jection of cap [AJ fits the collar groove [BJ surely.
•Install the drive chain on the rear sprocket, and install the
front wheel.
Olnsert the rear axle from left side.
•Adjust the drive chain slack.
•Tighten the rear axle nut.
Torque - Rear Axle Nut: 108 N·m (11.0 kgf-m, 80 ft-lb)
•Insert a new cotter pin [AJ.
NOTE
o
When inserting the cotter pin, if the slots in the nut do
not align with the cotter pin hole in the axle, tighten the
nut clockwise [BJ up to next alignment.
o
It should be within 30 degree.
OLoosen once and tighten again when the slot goes past
the nearest hole.
•Bend the cotter pin [AJ over the nut.
• Check the rear brake effectiveness:
A
WARNING
Do not attempt to ride the motorcycle until a full
brake pedal is obtained by pumping the brake pedal
until the pads are against the disc. The brake will
not function on the first application of the pedal if
this is not done.
WHEELS/TIRES 9-5
GJ040605S1
C
GJ040606S1
C
®
A
I
IM07000BS1
C
A
gj040201.
tif

Advertisement

Table of Contents

   Also See for Kawasaki KLX250R

This manual is also suitable for:

Klx250

Comments to this Manuals

Symbols: 0
Latest comments: