Download  Print this page

Clutch; Clutch Plate Assembly Inspection; Clutch Plate Assembly Adjustment - Kawasaki KLX250R Owner's Manual

D-tracker.
Hide thumbs

Advertisement

5-6 ENGINE RIGHT SIDE/LEFT SIDE
Clutch
Clutch Plate Assembly Inspection
•Inspect the friction plate thickness (see Clutch Plate,
Wear, Damage Inspection).
•Measure the length [A] of the clutch plate assembly as
shown.
Torque - Clutch Spring Bolts: 3.2 N·m (0.33 kgf.m, 29 in-lb)
Clutch plate Assembly
Standard:
30.3 - 30.9 mm
*If the length is not within the specified range, adjust the
length (see Clutch Plate Assembly Adjustment).
Clutch Plate Assembly Adjustment
•Inspect the clutch plate assembly length, and then re-
place the steel plate(s) which brings the length within the
specified range.
•Remove:
Spring Bolts
Spring Holders
Springs
Spring Plate
•Replace the standard steel plates(5 Pcs) using following
steel plates of N0.1 or N0.3.
Part No.
Thickness
1
13089-1117
1.2 mm
2
13089-1094
1 .6 mm (Standard)
3
13089-1116
2.0 mm
NOTE
OOo not use the steel plate of 1.2 mm and 2.0 mm thick-
ness at the same time.
OAfter replacing the friction plate(s) or steel plate(s),
make sure to measure the overall thickness of the plate
assembly and adjust if necessary.
•Install the removed pats, and inspect the clutch plate as-
sembly length.
Olnstall the last friction plate [A] fitting the tangs in the
grooves in the housing as shown.
Torque - Clutch Spring Bolts: 3.2 N-m (0.33 kgf-m, 29 in-lb)
@!IS: •
l>
I I<
GF060601
S1
C
GF060401S1
C

Advertisement

Table of Contents

   Also See for Kawasaki KLX250R

This manual is also suitable for:

Klx250

Comments to this Manuals

Symbols: 0
Latest comments: