Download  Print this page

Switches And Sensor; Throttle Sensor Removal And Installation; Throttle Sensor Inspection - Kawasaki KLX250R Owner's Manual

D-tracker.
Hide thumbs

Advertisement

15-24 ELECTRICAL SYSTEM
Switches and Sensor
Throttle Sensor Removal and Installation
CAUTION
Do not remove the throttle sensor [A] because the
sensor's mounting position must be adjusted once
it is removed.
•To replace the sensor, see Throttle Sensor Position Ad-
justment.
Throttle Sensor Inspection
•Remove the fuel tank (see Fuel System chapter).
• Use a suitable hose to connect the fuel tank and the car-
buretor.
•Thoroughly warm up the engine.
•Check:
Idle Speed (see Periodic Maintenance chapter)
Battery's state of charge (see this chapter)
•Turn the ignition switch OFF.
• Disconnect the throttle sensor connector and connect the
adapter between the connectors.
Special Tool - Throttle Sensor Setting Adapter:
57001
-1400
•Measure the throttle sensor's input voltage.
OConnect the hand tester to the adapter.
Hand tester(+)---+ blue lead (color of lead on throttle
sensor)
Hand tester(-)---+ black lead (color of lead on throttle
sensor)
Throttle Sensor Input Voltage
Standard:
4.9 - 5.1 V
•If the input voltage is out of standard, inspect the IC ig-
niter.
•Connect the hand tester to the adapter.
Hand tester(+) - yellow lead terminal
(color of lead on throttle sensor) [C]
Hand tester(-) - black lead terminal
(color of lead on throttle sensor) [D]
•Start the engine.
•Measure the sensor's output voltage at idle speed.
Throttle Sensor Output Voltage (at idle)
Standard:
0.9 -
1.1 V
A
GP25007BS1
C

Advertisement

Table of Contents

   Also See for Kawasaki KLX250R

This manual is also suitable for:

Klx250

Comments to this Manuals

Symbols: 0
Latest comments: