To Convert Back Into Workmate Mode; Features & Applications; Service Information; Full Two-Year Home Use Warranty - Black & Decker Workmate 525 Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

588974-03,01,WM525*
Fig. 14 & 11: To Convert Back Into Workmate Mode
Note: Ensure Toe Plate is in the upright (storage) position.
1. Push the Transition Lever (shown in the inset of Fig. 11) to the right to unlock the unit.
2. Fig. 14: Push down on the upper cross member as shown.
3. Fig. 11: Continue to push down until the unit locks (pins lock into outside frame) in
the Workmate position.
Features & Applications:
Fig. 15: Vertical Clamping
Note: Rear Vise Jaw must be in the rear keyhole position.
Rotate the Vise Hand Cranks counter clockwise to open the workmate jaws to the
extreme front position. Pull the vertical locking buttons located on each side of the Vise
Brackets back toward the handle end of the unit as shown in the inset, and lift up on the
Front Vise Jaw, rotating until the jaw locks in the vertical position.
Fig. 16: Swivel Grips
The four supplied Swivel Grips (N) can be used in any of the holes in the Front and
Rear Vise Jaws. The Swivel Grips are used to extend the size of your Workmate's
holding capacity.

Service Information

Black & Decker offers a full network of company-owned and Authorized Service
locations throughout North America. All Black & Decker Service Centers are staffed with
trained personnel to provide customers with efficient and reliable power tool service.
Whether you need technical advice, repair, or genuine factory replacement parts,
contact the Black & Decker service location nearest you. To find your local service
location, refer to the yellow page directory under "Tools—Electric" or call:
1-800-54-HOW-TO.

Full Two-Year Home Use Warranty

Black & Decker (U.S.) Inc. warrants this product for two years against any defects in
material or workmanship. The defective product will be replaced or repaired at no
charge in either of two ways:
The first, which will result in exchanges only, is to return the product to the retailer from
whom it was purchased (provided that the store is a participating retailer). Returns
should be made within the time period of the retailer's policy for exchanges (usually 30
to 90 days after the sale). Proof of purchase may be required. Please check with the
retailer for their specific return policy regarding returns that are beyond the time set for
exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned
or authorized Service Center for repair or replacement at our option.
Proof of purchase may be required. Black & Decker owned and authorized service
centers are listed under "Tools-Electric" in the yellow pages of the phone directory.
This warranty does not apply to accessories. This warranty gives you specific legal
rights and you may have other rights which vary from state to state. Should you have
any questions, contact the manager of your nearest Black & Decker Service
This product is not intended for commercial use.
See 'Tools-Electric'
– Yellow Pages –
for Service & Sales
9/24/04
2:07 PM
Page 5
4
Center.
Black & Decker
(U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286
U.S.A.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents